10
• Test incomplete due to
removing the strip during
measuring.
Follow Chapter 3.1 and repeat the test with a
new strip. Do not remove the strip before the
test is completed.
• Problem with strip. Follow Chapter 3.1 and repeat the test with
the same strip. If the problem persists,
please contact local distributor for service.
• Improper code strip. Repeat the coding procedure (Chapter 2.3).
If the problem persists, please contact local
distributor for service.
• Test result is lower than
the range listed on
Chapter 8.
Follow Chapter 3.1 and repeat the test with
a new strip. If the problem persists, please
contact local distributor for service.
• Test result is higher than
the range listed on
Chapter 8.
Follow Chapter 3.1 and repeat the test with
a new strip. If the problem persists, please
contact local distributor for service.
To Next Page
Loading...