Glen Dimplex GDW14S-2 - Rinse Aid Reservoir Management

16
1 2
Filling the Rinse Aid Reservoir
The regularity of the dispenser needing to be relled depends on how often dishes are washed and
the rinse aid seing used. The Rinse Aid ( ) indicator will be lit when more rinse aid is needed.
1. Remove the rinse reservoir cap by lifting up the handle.
2. Pour the rinse aid into the dispenser, being careful not to overll.
3. Close the cap after all.
Do not overll the rinse aid dispenser.
3
Adjusting the Rinse Aid Reservoir
To achieve a beer drying performance with limited rinse aid, the dishwasher is designed to adjust the
consumption by user. Follow the below steps.
1. Close the door, press the Power ( ) buon, to switch on the dishwasher.
2. Within 60 seconds after switching on, press the Program ( P ) buon for more than 5 seconds,
and then press the Delay Start ( ) buon, the Rinse Aid ( ) indication blinks as 1Hz frequency.
3. Press the Program ( P ) buon again to select the program according to your using habits,
the seing will change in the following sequence: d1->d2->d3->d4->d5->d1.
The higher the number, the more rinse aid the dishwasher uses.
4. Leave for 5 seconds or press the Power ( ) buon to complete the setup and exit the seing
mode.
OPERATION