17
Sleep Mode – Some Shark controllers may be factory supplied with the SLEEP feature
that automatically turns off the Shark if no joystick movement is detected within a
certain period (programmable).
When Wake Style has been set to “Joystick and Buttons”, pressing any button or
displacing the joystick will bring the system out of Sleep mode.
When the Wake Up style has been set to Buttons only, pressing the On/Off button
ONLY will bring the system out of Sleep mode.
Driving SHARK – Moving the joystick will cause the powerchair to move in that
direction. The amount of joystick movement will determine the speed that the
powerchair will move in that direction.
A user may adjust the top speed of their powerchair to suit their individual needs or
environment by turning the speed control dial.
Simply turn the speed control dial fully clockwise to travel at top speed when the
joystick is pushed fully forward.
The top speed is progressively reduced as the speed control dial is turned counter
clockwise.
All driving parameters (speed, acceleration, etc) can be further programmed to suit
individual needs and preferences of each user.
Using the Horn – Press the Horn Button located at the front of the Shark controller in
front of the joystick – Grey button
The Horn will sound for as long as the button is pressed.
Locking the Shark – Some Sharks may be supplied factory programmed with a Lock
feature to prevent unauthorized people from turning the Shark on.
To Lock Shark – While the power is On, press and hold the power button for 2
seconds. The display will turn off immediately.
After 2 seconds all LED’s will flash briefly and the horn will sound a short beep.
The powerchair will then turn off.
To Unlock Shark – While Shark is Locked, press the On/Off button to turn Shark On.
All LED’s will flash briefly. The LED’s will then perform a slow right to left
countdown.
Press the Horn button twice before the countdown has completed (approximately 10
seconds)
The current state-of-charge will then be displayed and Shark may be operated
normally.
Charging Shark – Plug the battery charger into the charging socket located at the front
of the Shark unit.
To Next Page
Loading...
Need help?
General
