Need help?Do you have a question about the Gliderol Garage door and is the answer not in the manual?
Prepare and position door panels centrally for installation.
Fasten wall fix brackets and flag brackets to vertical tracks.
Prepare door panels, attach cable brackets, and install hinges.
Install subsequent door panels, rollers, and check alignment.
Attach top corner brackets and reinforcing struts to the final panel.
Loosen top bracket slides for roller adjustment.
Attach flag brackets and secure horizontal tracks with steel angles.
Adjust and tighten top door panel roller brackets for clearance.
Attach bearing plates to horizontal angles on both tracks.
Secure spring anchor plugs, place springs and cable drums on shaft.
Wind springs using a bar to achieve desired door tension.
General| Operation | Automatic |
|---|---|
| Material | Steel |
| Motor Type | AC |
| Operating Voltage | 240V |
| Remote Control | Yes |
| Safety Sensors | Yes |
| Type | Sectional |
To Next Page
