Global Laser’s heavy duty clamp has parallel and vertical adjustment which allows the user to
aim the laser in any required direction or angle, the robust aluminium construction also assists
in conducting heat away from the laser body as well as prevents movement due to shock and
vibration. The base plate of the heavy duty clamp has a series of threaded holes to allow the
Heavy duty clamp to be securely fastened to stable surface An magnetic base is also available
which simply screws in to the base of the heavy duty clamp and allow it to be tted to a ferrous
surface.
A range of brackets are also available with M5 holes at regular intervals are also available to
complement the mounting clamps.
B12 30cm/12” metal mounting bracket with M5 holes at regular intervals.
B6 15cm/6” metal mounting bracket with M5 holes at regular intervals.
B4 10cm/4” metal mounting bracket with M5 holes at regular intervals.
B2 Right angles 10cm/4” metal mounting bracket with M5 holes at regular intervals.
BS A set containing one of each of the above brackets
5a Mounting the LaserLyte L Series in the Heavy Duty Clamp
1. Un-tighten allen screw A (see drawing E) with the supplied allen key.
2. Slide the laser into the mounting hole (see drawing D) and tighten allen key A.
3. For vertical adjustment of the laser un-tighten grub screw A (see drawing E). This will allow
the section mounting the laser to be adjusted. When the vertical posting is complete re-tighten
grub screw A.
4. For horizontal adjustment of the laser un-tighten grub screw B (see drawing E). This will allow
the main body of the mount to be moved. When the horizontal positing is complete re-tighten
grub screw B.
5. To secure the Heavy duty clamp to a surface machine screw or studs can be used in conjunc-
tion with the base section (see drawing E for thread details).
5b Mounting the LaserLyte L Series in the Heavy Duty Clamp with the Magnetic Base
1. Un-tighten allen screw A (see drawing E) with the supplied allen key.
2. Slide the laser into the mounting hole (see drawing E) and tighten allen key A.
3. For vertical adjustment of the laser un-tighten grub screw A (see drawing E). This will allow
the section mounting the laser to be adjusted. When the vertical posting is complete re-tighten
grub screw A.
4. For horizontal adjustment of the laser un-tighten grub screw B (see drawing E). This will allow
the main body of the mount to be moved. When the horizontal positing is complete re-tighten
grub screw B.
5. To secure the magnetic base to the heavy duty clamp simple screw the stud on the top of the
magnetic base into the centre hole in the base of the heavy duty clamp until tight.
6. Remove the keeper from the magnetic base and place on a ferrous surface to secure.
desired position and tighten Phillips screw A to lock into position.
To Next Page
Loading...
Need help?
General
