Global 244280 - Introduction; General and Safety Information; Specifications

244280 www.globalindustrial.com 1
1. INTRODUCTION
General and Safety Information
 For use in dry environments only.
 This product uses a NI-MH battery. Dispose of according to local laws and
regulations.
 Read and understand all operating instructions before using this product. Keep
this manual for future reference.
 Allow sufficient warm up time. Turn the scale on and allow up to 10 minutes for internal
components to stabilize before weighing.
 Record the weight shortly after placing a load on the platter. Leaving loads in place for
extended periods may vary the load cell’s output signature and may result in a less
accurate reading.
 Avoid extended exposure to extreme heat or cold. Optimum operation is at normal room
temperature. See operating temperature range in the specifications table. Allow the scale
to acclimate to room temperature before using.
 When storing the scale for extended periods, the battery must be charged every 90 days
to avoid premature performance degradation. Over time, the operating time per charge
will degrade. If the operating time is no longer acceptable even after recharging, the
battery must be replaced. Contact Global Industrial for additional information.
 Electronic scales are precision instruments. Do not operate near cell phones, radios,
computers or other electronic devices that emit radio frequencies that may cause
unstable readings.
Specifications
Model
244280
Max. Capacity
60 lb (30 kg)
Readability
0.002 lb (1 g)
Display Resolution
1:30000
Min. Recommended
Weight
0.04 lb (20 g)
Min. sample Weight
1%FS
300g
Construction
Stainless steel pan, plastic housing
Weighing Units
kg / lb
Calibration unit
kg / lb
Modes
Weighing, Counting, Check Weighing, % weighing, Accumulation
Weight Display
1-Window backlit LCD display, 1 inch high, 6 1/2 digits, 7-segment
Zero Range
Power-on zero range: calibration zero point±10%FS;
ZERO key range: power-on zero±5%FS
Tare Range
Full capacity
Stabilization Time
<5 seconds
Operating
Temperature
32° to 105°F (0° to 40°C)