“Global Pool Products is committed to engineering and manufacturing world class products in the pool industry”
Global Pool Products
1330 Pigeon Rd
Bad Axe, MI 48413 Information contained in this document is proprietary and confidential to
P: 989-269-5900 - TF: 866-712-0606 Global Pool Products and not to be reproduced without
Fax: 989-269-5902 written consent from Global Pool Products.
www.global-poolproducts.com
Page | 12
Installing the foam gasket and butyl on the lower flume
a. Install the shorter 34” foam-rubber gasket from the seal kit tube on the lower flume, start at the
top and install it following the curve of the flume, cut off any excess and discard it
b. Measure the center of lower flume, use the point where the foam- rubber gasket stops on the
right and the point level to that on the left to find center, put a mark with a sharpie low enough
so it is not visible once the slide is assembled
c. From the roll of butyl, cut a piece of butyl 30” long and mark the center with your thumbnail
d. Line the center of the lower flume to the center of the 30” long butyl (paper side facing you),
place it directly under the foam-rubber gasket following the curve of the lower flume, make sure
they are touching to ensure proper placement
e. Firmly press in the butyl to ensure it is secure to the flume, then remove the paper backing from
the butyl
Points used to find center.
To Next Page
Loading...