6 | GloboFleet
®
Downloadkey II user manual | © 2014 Buyond GmbH
Connecting the Downloadkey
to VDO DTCO 1381
To download data from the Siemens VDO DTCO
1381 nd the interface behind the ap which is loca-
ted between the two card slots. Tap with your nger
on the spot of the ap where you can see a small
hole. After that the ap will open and you can see the
interface. Plug in the downloadkey in the port.
The download will only start if a company card, con-
trol card or a work shop card is installed in your ta-
chograph.
Close the ap after the download has nished.
Attention:
If the „FAIL LED“ comes on the download was not successful.
In this case, please check that all steps of the instructions have
been complied with or contact our support team.
(Refer to P.12-15)
To Next Page
Loading...