22
Rev.10.15
How to start a program
Once you have selected a program, the following entries will appear:
- Start;
- Electrode placement;
Select Start to start the program and increase the channel intensity in the following
screen.
Increase/decrease intensity
To increase/decrease the intensity of the single channel, press the Up and Down
buttons of the corresponding channels.
To increase/decrease the intensity of all channels simultaneously, press
the P+ or P- buttons.
Visualization during a program execution
While a treatment is executing, the display shows the name of the program (at the
top), the number of total phases and the phase in progress, the remaining time of
the phase in progress and the type of the wave used (EMS, TENS… ). In the
programs with intermittent stimulation, the time countdown graphically represents
the work or the rest phase.
How to pause a program
Press OK to pause a program and eventually press OK again to return to the
program. The intensity indicators will be reset to zero every time the treatment is
stopped or restarted.
How to modify the duration of the treatment
When a program is running you can press the fn button to modify the duration of
the treatment. After pressing the fn button increase or decrease the duration of the
phase using the P + and P- buttons.
How to stop a program
When stopping a program before its end, hold down OK for 3 seconds to turn the
device off.
How to skip a phase
In order to pass to a next phase before the end of the one in progress, press and
hold the RIGHT button for 3 seconds.
To return to the previous phase, press the left (back) button for 3 seconds.
To Next Page
Loading...