Glow-worm Opulence 2 BBU - Heat Settings

Supplied By www.heating spares.co Tel. 0161 620 6677
18221098C
5 L i g h t i n g , T e s t i n g a n d F i t t i n g o f I n t e r n a l P a r t s
Diagram 5.16
APPLIANCE OFF
IGNITION POSITION
AND CENTRE
SECTION
FLAME EFFECT
CENTRE SECTION
FLAME EFFECT
WITH OUTER
SECTIONS
FUELBED GLOW
CENTRE AND
OUTER SECTIONS
FLAME EFFECT
WITH FUELBED
GLOW
FULL FLAME
EFFECT WITH
FUELBED GLOW
5154
5.4 Heat Settings
Light the fire front burner as the relevant part of
Section 5.1.
Refer to diagram 5.16.
At tap position 1 - centre section flame effect.
At tap position 2 - centre section flame effect with outer
sections fuel bed glow.
At tap position 3 - centre and outer sections flame effect
with fuel bed glow.
At tap position 4 - (full on) full flame effect and fuel bed
glow.
In the unlikely event of the flame going out when the fire
front burner is on, then turn off. Wait 3 minutes before
relighting.
If relighting for any other reason, wait 2 minutes before
doing so.