Using two hands, gently pull the laser arm to the front of your Glowforge
This will expose the rear Pro Shield so you can easily remove it.
Remove the back Pro Shield from the inner back wall of your Glowforge
Turn the black finger screws on either end of the Pro Shield counterclockwise to unscrew
them, then lift the shield away from the wall.
Reinstall your crumb tray, close the front door, and turn on your Glowforge!
Instructions for installing your crumb tray are available.
Your Glowforge Accessory Pack
It’s time to open your Glowforge Accessory
Pack. Inside you’ll find your jet black ferrous
steel crumb tray, power cord, an exhaust
hose, and two ring clamps.
Copyright Glowforge, Inc. 2020 28
To Next Page
Loading...