The trip odometer can tell
you
how far your vehicle has been driven since
you last set the trip odometer to zero. Make sure the button is completely
depressed to reset the trip odometer.
To set the trip odometer on the standard cluster to zero, fully depress the
button near the readout.
The trip odometer on the digital cluster will appear in place
of
your regular
odometer when you press down on the
Trip
button.
To
reset the trip
odometer on the digital cluster, press down on the
Reset
button. To change
back to the regular odometer, press down on the
Trip
button again.
Tachometer
The tachometer
displays the engine
speed in revolutions
per minute (rpm). It
is
available only with the
digital speedometer.
NOTICE:
Do
not operate the engine with the tachometer in the red area,
or engine damage may occur.
Warning Lights, Gages and Indicators
This section describes the warning lights and gages that may be
on
your
vehicle. The pictures will help you locate them.
Warning lights and gages can signal that something is wrong before
it
becomes serious enough to cause an expensive repair or replacement.
Paying attention
to
your warning lights and gages could also save
you
or
others from injury.
Warning lights go on when there may be or is a problem with one of your
vehicle’s functions.
As
you will
see
in the details on the next few pages,
some warning lights come
on
briefly when you turn the ignition key
just
to
let you know they’re working.
If
you
are
familiar with this section,
you
should
not
be alarmed when this happens.
2-67
To Next Page
Loading...
