3-16 Seats and Restraints
2. Place the guide over the belt,
and insert the two edges of the
belt into the slots of the guide.
3. The belt should not be twisted
and it should lie flat. The elastic
cord must be under the belt and
the guide on top.
{
Warning
A safety belt that is not properly
worn may not provide the
protection needed in a crash. The
person wearing the belt could be
seriously injured. The shoulder
belt should go over the shoulder
(Continued)
Warning (Continued)
and across the chest. These parts
of the body are best able to take
belt restraining forces.
4. Buckle, position, and release the
safety belt as described
previously in this section. Make
sure the shoulder portion of the
belt is on the shoulder and not
falling off of it. The belt should
be close to, but not contacting,
the neck.
To Next Page
Loading...
