5-4
Signal-Stat Turn Signal and Hazard
Warning Flasher (If Equipped)
If you have this system, it lets you warn others. It also
lets police know you have a problem. It makes your
front and rear turn signal lamps flash on and off, but
they won’t flash if you’re braking.
The switch is on the end of the signal
-stat housing.
To make it work, pull out on the hazard lever until it
locks into place. It works no matter what position your
key is in, and even if the key isn’t in.
To turn off the flasher, move
the turn signal lever either
up or down. Then move the
signal lever back to the
center position.
When the hazard warning flashers are on, your turn
signals won’t work.
Other Warning Devices
If you carry reflective triangles, you can set one up
at the side of the road behind your vehicle in the
recommended manner per FMCSR (Federal Motor
Carrier Safety Regulation) Section 392.22, to
warn others.
To Next Page
Loading...
Need help?
General
