GMP 32800 - Every 100 Hours or 6 Months; Checking the Hydraulic Fluid Level; Changing the Hydraulic Fluid

To Next Page

To Previous Page

Page 5

GeneralMachineProducts(KT),LLC

Every 100 hours or 6 Months

Do the Daily and 3-monthly jobs plus:

Check:

 Tightness of nuts, bolts, screws and hose fittings

 Flow and pressure output

Change

 Main hydraulic filter

 Hydraulic fluid

 Engine oil. (See Engine Manufacturer's

Handbook)

Clean

 Fuel strainer

 Spark plug

Check

 Spark plug gap

Note: For detailed maintenance procedure, refer to Engine Manufacturer’s Handbook.

Checking the Hydraulic Fluid Level (Fig. 4)

1. Prepare the Machine

Position the machine on level

ground. Switch off the engine and

allow it to cool down.

2. Check the Hydraulic Fluid Level

a. Check the hydraulic fluid level

using sight gauge A.

b. If necessary top up the hydraulic

fluid through filler B.

Note: Use only the recommended hy-

draulic fluid.

Changing the Hydraulic Fluid (Fig. 4)

Note: The illustration shown is for a typical machine.

1. Position the machine on level ground. Switch off the engine and allow it to cool

down.

2. Drain the Hydraulic Fluid

a. Place a container of a suitable size below the tank drain plug C to catch the fluid.

b. Remove drain plug C and filler cap B and allow fluid to drain out.

Fig.4