GMP 32800 - Troubleshooting Guide; Engine will Not Start; Spares

Page 7
GeneralMachineProducts(KT),LLC
Note: It is important that after maintenance, the tubular frame is restored to its operat-
ing position and that the clips A are securely fitted.
Note: When the machine is to be lifted using the balanced lifting point C, it is important
to ensure that the clips A are in place and securely fitted.
TROUBLESHOOTING GUIDE
Engine Will Not Start
 Check gas level
 Check throttle in "on" position
 Check emergency stop button is "reset" on either the Tornado or the Powered Duct
Rod Pusher
 Ensure hoses are connected from power pack to blower (if they are not connected or
have a faulty coupling, engine will not turn over).
 Contaminated gas
Difficult to Start Engine
 Check above points
 Ensure gas has additional additive
 Engine may be flooded
 Check hydraulic valve on blower unit is switched “off”
 Check spark plug
Engine is Running Erratic
 Ensure additive is mixed with gas
 Damage to throttle
SPARES
For spare parts always provide the part number and serial number.
General Machine Products (KT), LLC
3111 Old Lincoln Highway, Trevose PA 19053 USA
TEL: +1 215 357 5500 ● FAX: +1 215 357 6216 ● E-MAIL: info@GMPtools.com
Website: www.GMPtools.com
Please give as much information as possible to ensure correct identification and
supply of spare parts