CAUTION FOR MEMORY CARD
Overtime, memory degradation can occur and should be replaced periodically.
To prevent incompatibility problems, please use only a genuine GNET memory
card. The GNET memory cards are specically designed to operate with our GNET
systems and are covered under our warranty program.
When a vehicle accident occurred, it is recommended to remove the memory card
from the device and save the data to a computer immediately. When the memory
card is full, the data will be overwritten, and the accident data will be lost.
Please be sure to remove the memory card only after the recording LED is o.
Otherwise, if removed too early, video data could be lost or corrupted. This can
also shorten the card’s lifespan.
Please do not interchange / swap the memory cards between other products. Data
may be erased and lost if the memory card is automatically formatted.
It is recommended that the memory card be formatted at least twice a month for
product and lifespan maintenance. For best results, please use the ocial SD
Formatter (www.sdcard.org).
GNET System dash cameras can support memory card (SD) capacities ranging from
32GB to 512GB.
When a new or used memory card is inserted into the device for the rst time, the
system will go into standby mode for 3 to 5 minutes. Please do not attempt to
remove the memory card during standby mode or when the device is formatting
the card.
It is possible to format the memory card in the GNET application for Mac and PC.
Please visit the GNET SYSTEM’s website at:
https://www.gnetsystem.com/eng → SUPPORT → DOWNLOAD
To Next Page
Loading...
