7. HOW TO USE
Normal Record
Impact Record
Parking Record
Motion recording
- Automatically normal recording is initiated.
- Security LED will blink every 2 seconds.
- If there is impact on device, the record LED will be blink as recorded event recording at event
folder in SD card.
- Event recording will be automatically changed to continuous recording.
- While device is under parking mode, the device will record any movement around car within 3m as
motion recording.
- Security LED will quickly blink.
- Motion recording will be automatically changed to parking mode.
- When Acc voltage is released after setting parking mode, Parking mode will be activated in
10 seconds.(3 wired connection)
- When Acc voltage inputs, Normal recording will be activated(3 wired connection)
- With No movement for 10 minutes or if the voltage drops 0.5~1.0V, Parking mode will be activated
after 2 minutes(2 wired connection)
- The normal recording will be activated if there is impact with device or voltage rises over
1.0v(2 wired connection)
- Parking mode is 10 frame. which makes record time to be increased
- Security LED will be blink from up and down every 4 seconds.
·Record type
26
G-Net system DASH CAM
To Next Page
Loading...
