10. The 3/8”x 2-1/2” pivot bolt indicated by the arrow in (Fig. 1) is the pivot point for
the Adjustable/Floating handle. Remove the bolt and insert the handle into the
engine-mounted handle bracket. Reinstall the bolt into the bracket, passing it
through the hole at the end of the handle. Be sure to include the wire loom to
secure the cables as it was shipped. Install the washer and nut and tighten the nut
firmly or until a slight amount of drag can be felt while pivoting the handle up and
down from the grip.
37 hp Vanguard Shown
Check to ensure that the throttle linkage on the engine moves throughout its full
range when the throttle lever is depressed and that it returns to the idle position
when released.
To Next Page
Loading...