To Next PageTo Next Page
Need help?Do you have a question about the Go Power GP-1000 and is the answer not in the manual?
General| Model | GP-1000 |
|---|---|
| Type | Pure Sine Wave Inverter |
| Input Voltage | 12V DC |
| Output Voltage | 120V AC |
| Output Waveform | Pure Sine Wave |
| Weight | 8.0 lbs (3.6 kg) |
| Dimensions | 11.7 x 8.3 x 3.6 in (297 x 210 x 92 mm) |
| Output Frequency | 60 Hz |
| Efficiency | 90% |
| THD | < 3% |
| Cooling | Fan Cooled |
| Output Power | 1000W |
| Surge Power | 2000 Watts |
| Protection Features | Over Voltage, Under Voltage, Overload, Short Circuit, Over Temperature |
Addresses Go Power!'s responsibility for system components, compatibility, and liability limitations.
Details the display, switches, and outlets on the front panel of the GP-1000.
Explains the overload condition, status LED behavior, and troubleshooting steps.
Covers operating voltage ranges, low battery warnings, and shutdown conditions.
Details solutions for audio buzz in stereo systems and television interference.
Describes the function of the ON/OFF switch and the power idle current.
Specifies criteria for inverter installation: dry, cool, ventilated, safe, and near batteries.
Lists available Go Power! DC Installation Kits for connecting the inverter.
Provides recommendations for DC input cable gauge and length for high amperage operation.
Specifies the type and amperage of the fuse required for the inverter.
