9
IMPORTANT SAFETY INSTRUCTIONS
Please save these instructions
Read all the instructions and cautions before
beginning installation.
Goal Zero recommends installation of the Yeti Link Vehicle Charging kit be
installed by trained professional. Under no circumstance should the Goal
Zero Yeti Link be installed with out the technical skills, technical information,
tools and equipment required to properly complete the necessary
procedures
Do NOT install a secondary battery in between the Battery and the Yeti Link
Module
Improper connections will damage the Yeti Link Module/Accessory cables
and/or cause serious injury or death. Be sure that all wiring is connected to
the appropriate polarity
Make sure cables are securely connected. Check cables periodically
especially before and after uneven roadways
Confirm cables are installed correctly with no risk of pinching or abrasion.
Pinching cables or any means of exposing internal cables can lead to
malfunctions or fires
Keep live wires , terminals, and other bare parts away from contact with
each other and other metal parts
Always wear eye protection when making battery connections
Always use rubber insulating grommet when drilling through steel panels to
run the EC8 cable
Never route electrical cables across sharp edges
Never route electrical cables near parts that get hot
Never route electrical cables over battery terminals
Never route electrical cables through or near moving parts
Electrical cables should be safe from road spray, rain runoff, sand or gravel
from road surface.
Goal Zero rejects any liability for problems and damage caused by the
system being installed by untrained personnel.
The vehicle owner is responsible for the correct operation of the appliance
Keep away from sources of heat (e.g. too close to exhaust system
components or directly behind the radiator, etc.).
To Next Page
Loading...
