4
o On when the level is below the sensor
- Digital output 2, select (yellow and red cable)
o Always off
o Always on
o On when the level is above the sensor
o On when the level is below the sensor
- Calibration, select (The fluid level must be above or below the sensor
when performing the calibration)
o Full tank
o Empty tank
12
Security
Here you can choose Open to make your sensor available to everyone,
or you choose to Lock it to your phone, i.e. the phone from which you do
the installation.
13
After performing this configuration, you can start the Calibration. It will
take about 10 seconds. When it is done you will get OK on your phone.
The sensor is now ready to work.
14
On the Show screen you have some small icons
- Number of Bluetooth icons = number of sensors
- Extra alarm when full = Red
- (if not = Green)
- Blue icon, saying that the sensor is Bluetooth connected
to your phone. Red icon, no Bluetooth connection
- Bar chart, animation. The sensor is measuring
- The green bar = the fluid level
- Extra alarm when empty = Red
(if not = Green)
- Cogwheel, click for going to Settings pages
- If you have more than one tank, scroll left-right
To Next Page
Loading...