Gobius Pro, Instructions on paper, August 2019-1
Gobius Sensor Technology AB
Ljungåsvägen 2
Phone +46 (0)31 650170
www.gobius.se
info@gobius.se
Hi.
This information is for you who likes to have them written on paper.
You will get the same and more updated info when downloading the App,
Gobius, from Internet, Google play and App Store.
Please note that you have to get the App before installing the sensor.
You do all settings from the App.
After installation you don’t need the App for using the Gobius Pro.
If you connect a panel like our Gobius fish with 2 LEDs in red and green,
you don’t need your phone to use the sensor.
1
Download the Gobius App from Google Play or App Store.
2
In the Gobius Pro box you get:
- 1 sensor with 2 m cable
- 1 tank surface 3M Cleaner
- 1 extra 3M sensor tape
- 1 panel (the Gobius fish) with
1 red and 1 green LED light
3
Check the tank wall thickness. If it’s thicker than the specification,
Gobius Pro will not work.
- Stainless Steel & Steel 3 mm
- Polyethene, 12 mm
- Aluminium, 5 mm
- Fibre Glass, 8 mm
4
There are some more important things you have to consider
before mounting the sensor on the tank wall.
- Don’t put the sensor closer than 35 mm from an edge,
or another sensor and always on a vertical side of the
tank.
- The tank wall temperature has to be above + 20 C (+ 68 F).
If it’s below the tape will not work satisfying. A heat gun
or a hair dryer can be useful when you need to heat up
the tank wall. After the installation the sensor will work
between -10 C and + 60 C.
To Next Page
Need help?
General
