To Next PageTo Next Page
Need help?Do you have a question about the Godox TT685F and is the answer not in the manual?
General| Type | Slave flash |
|---|---|
| Flash modes | Auto, High-speed synchronization, Manual, Second curtain synchro |
| Display type | LCD |
| Product color | Black, Red |
| Flash coverage | 20 - 200 mm |
| Channels quantity | 32 channels |
| Color temperature | 5600 K |
| Shooting distance | 0.6 - 10 m |
| Flash guide number | 60 m |
| Transmission range | 0 - 100 m |
| Operating frequency | 2400 MHz |
| Wireless connection | Yes |
| Auto power off after | 60 min |
| Flash duration (max power) | 1/20000 s |
| Flash duration (min power) | 1/300 s |
| Camera brands compatibility | Fujifilm |
| Brand specific flash systems | TTL |
| Approximate recycling time (max) | 2.6 s |
| Approximate recycling time (min) | 0.1 s |
| Battery type | AA |
| Number of batteries supported | 4 |
Weight and Dimensions| Depth | 76 mm |
|---|---|
| Width | 64 mm |
| Height | 190 mm |
| Weight | 410 g |
Lists compatible Fuji camera models and their supported functions.
Illustrates and labels the physical components of the TT685F flash unit.
Describes the buttons and controls located on the flash unit's operation panel.
Explains the information displayed on the flash's LCD screen and its indicators.
Lists optional accessories available for purchase to enhance photography effects.
Allows adjustment of flash output for correct exposure in TTL mode.
Enables flash synchronization with high shutter speeds for fill-flash portraits.
Creates a light train effect by firing the flash just before the shutter closes.
Table explaining stop changes for flash output adjustment.
Using flash as a wireless slave with optic sensor for sync firing.
Using flash as a wireless slave, ignoring pre-flash.
Formula to calculate shutter speed for stroboscopic flash.
How to switch between normal and wireless flash modes.
FEC settings on master unit apply to slave units for consistent exposure.
Illustrates positioning for single slave unit autoflash.
Shows setup for two slave groups.
Shows setup for three slave groups.
Using FT-16S remote to control flash wirelessly.
Connecting flash via sync cord for camera synchronization.
How the AF assist beam functions and its settings.
How to use the built-in wide panel to extend flash coverage.
Indicates when the battery is low and needs replacement.
Information on how to upgrade the flash firmware via USB.
Explains protection against overheating and guidelines.
Lists other error prompts and their meanings.
Solutions for issues related to flash not firing or not charging.
Addresses problems like auto power-off and auto zoom not working.
Fixes for incorrect exposure and inadequate flash coverage.
