What to do if my Godox Camera Flash does not fire?
If your Godox Camera Flash isn't firing, ensure the mounting foot is securely attached to your camera. Also, check and clean the electrical contacts on both the flash and camera.
Why is my Godox TT685 Camera Flash underexposing or overexposing my photos?
If your Godox Camera Flash photos are consistently underexposed or overexposed, it might be due to using high-speed sync, which reduces the effective flash range. Alternatively, try setting the flash mode to TTL or manually adjusting the flash output.
What to do if photos have dark corners with Godox Camera Flash?
If your Godox Camera Flash photos show dark corners or only parts of the subject, check the flash coverage settings.
General| Zoom Range | 20-200mm |
|---|---|
| Color Temperature | 5600K ± 200K |
| Bounce Head | Yes |
| Swivel Head | Yes |
| Channels | 32 |
| Groups | 5 (A, B, C, D, E) |
| Compatible Cameras | Canon, Nikon, Sony, Fujifilm, Olympus/Panasonic, Pentax |
| Guide Number | 60 (m at ISO 100) |
| Flash Modes | TTL, Manual, Multi |
| Recycle Time | 0.1 to 2.6 Seconds |
| Power Source | 4 x AA batteries |
| Flash Duration | 1/300 - 1/20000 sec |
| Zoom Head | Yes |
| Tilt Angle | -7 to 90° |
| Wireless Range | Up to 100 meters |
| Dimensions | 64 x 76 x 190mm |
| Weight | 410g (without batteries) |
Details the physical components of the flash unit's body.
Explains the buttons, controls, and indicators displayed on the flash unit's panel and LCD.
Step-by-step instructions for mounting and removing the flash unit from a camera.
Explains TTL mode, how to use it, and adjust exposure compensation.
Explains how to use High-Speed Sync and Second-Curtain Sync.
Details flash output levels and configuring manual flash for off-camera high-speed sync.
Setting the flash to act as an optical slave unit (S1 or S2 mode).
Guide on calculating shutter speed for stroboscopic flash sequences.
How to switch modes, set up master/slave units, and manage communication channels.
Performing TTL autoflash shooting wirelessly with a slave unit.
Choosing TTL, M, or Multi mode for the master flash.
How to set master to manual mode and adjust group power outputs for wireless shooting.
Describes how each group fires at the set flash ratio.
How to set the flash to stroboscopic mode and configure frequency/flashes.
Visual examples of positioning for one, two, and three slave units.
Using Wireless Control Port, sync cord, and AF assist beam functions.
Step-by-step guide to creating catchlights in portraits using the built-in panel.
How to use the built-in wide panel for wider flash coverage.
Explains the low battery indicator and when to replace batteries.
Detailed steps on how to access and configure the flash's custom functions.
Explains overheating protection and lists error prompts (E1-E9) for troubleshooting.
Solutions for charging, firing, power, and auto zoom problems.
Advice for incorrect exposure and troubleshooting coverage issues.
To Next Page
