Restore Factory Settings
Hold the MODE button and power the flash trigger on, and all the parameters will
restore the factory settings.
Technical Data
Firmware Upgrade
This flash trigger supports firmware upgrade through the Type-CUSB port. Update
information will be released on our official website.
USB connection line is not included in this product. As the USB port is a Type-C
USB socket, please use Type-C USB connection line.
As the firmware upgrade needs the support of Godox G3 software, please
download and install the "Godox G3 firmware upgrade software" before
upgrading. Then, choose the related firmware file.
X2T-P
0-100m
2.4G
MSK
32
01-99
5
Large LCD panel, backlighting ON or OFF
72x70x58mm/90g
2413.0MHz-2463.5MHz
5dbm
Model
Wireless Flash
Transmission range (approx.)
Built-in wireless
Modulation mode
Channel
Wireless ID
Group
Other
Display
Dimension/Weight
2.4G Wireless Frequency Range
Max. Transmitting Power of 2.4G Wireless
Attentions
1. Unable to trigger flash or camera shutter. Make sure batteries are installed
correctly and Power Switch is turned on. Check if the transmitter and the receiver
are set to the same channel, if the hotshoe mount or connection cable is well
connected, or if the flash triggers are set to the correct mode.
2. Camera shoots but does not focus. Check if the focus mode of the camera or lens
is set to MF. If so, set it to AF.
3. Signal disturbance or shooting interference. Change a different channel on the
device.
4. Operating distance limited or flash missing. Check if batteries are exhausted. If so,
change them.
The Reason & Solution of Not Triggering in Godox 2.4G Wireless
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base
station, 2.4G wifi router, Bluetooth, etc.)
→ To adjust the channel CH setting on the flash trigger (add 10+ channels) and
use the channel which is not disturbed. Or turn off the other 2.4G equipment in
working.
2. Please make sure that whether the flash has finished its recycle or caught
up with the continuous shooting speed or not(the flash ready indicator is
lighten) and the flash is not under the state of over-heat protection or other
abnormal situation.
→ Please downgrade the flash power output. If the flash is in TTL mode, please try
to change it to M mode(a preflash is needed in TTL mode).
3. Whether the distance between the flash trigger and the flash is too close or
not
→ Please turn on the “close distance wireless mode” on the flash trigger (＜0.5m):
→ Please set the C.Fn-DIST to 0-30m.
- 46 -
- 45 -
To Next Page
Loading...
