The following table lists the available and unavailable custom functions of this flash.
C.Fn: Setting Custom Functions
Setting the Flash Trigger
Setting Signs
One-shoot
Full-shoot
APP
0-30m
1-100m
OFF
01-99
200j
360j
600j
Custom Function
SHOOT
DIST
ID
TCM
Function
APP
Triggering
distance
Wireless ID
TCM transform
function
Settings and Description
Only send triggering signals in the M & Multi mode
when camera is shooting
Send parameters and triggering signal when camera is
shooting(suitable for multi person photography)
Only send triggering signal when camera is shooting
(control the flash’s parameters by smartphone APP)
0-30m triggering
1-100m triggering
Off
Choose any figure from 01-99 (the current flashes
cannot use this function temporarily)
TT685/V860II series
AD200
AD360II
AD600
The power output values in the
M mode which are transformed
from TTL mode, being subjected
to the master flash when mixing
Setting the Flash Trigger
- 40 -- 39 -
Setting Signs
ON
OFF
ON
OFF
1/128
1/256
1/128 (0.1)
1/256 (0.1)
12sec
OFF
ON
IN
OUT
5 (A-E)
16 (O-F)
-3-+3
Settings and Description
ON
OFF
ON
OFF
The minimum output is 1/128 (change in 0.3 step)
The minimum output is 1/256 (change in 0.3 step)
The minimum output is 1/128 (change in 0.1 step)
The minimum output is 1/256 (change in 0.1 step)
Off in 12 seconds
Always off
Always lighting
Enable XProO to trigger flash
Export triggering signal to trigger other remote control
and flash
5 groups (A-E)
16 groups (0-F); 16 groups when the receiver end is
studio flash, which can only be set to M mode in this state
The contrast ration can be set as integral number from
-3 to +3
Custom Function
STBY
BEEP
STEP
LIGHT
SYNC
GROUP
LCD
Function
Sleep
Beeper
Power output
value
Backlighting
time
Sync cord jack
Group
Contrast ratio
of LCD panel
To Next Page
Loading...
