Godox XProO - Page 24

Model
Compatible cameras
Power supply
Flash Exposure Control
TTL autoflash
Manual flash
Stroboscopic flash
Function
High-speed sync
Second-curtain sync
Flash exposure
compensation
Flash exposure lock
Focus assist
Modeling lamp
Beeper
Wireless setting
ZOOM setting
TCM function
XProO
Olympus/Panasonic cameras (TTL autoflash)
Support for the cameras that have PC sync socket.
2*AA batteries
TTL
Yes
Yes
Yes
Yes
Yes, ±3 stops in 1/3 stop increments
Yes
Yes
Control the modeling lamp by the flash trigger
Control the beeper by the flash trigger
The receiver end can control the camera shooting through the
2.5mm sync cord jack
Adjust the ZOOM value by the transmitter
Transform the TTL shooting value into the output value in the M node
Technical Data
Model
Firmware upgrade
Memory function
Wireless Flash
Transmission range (approx.)
Built-in wireless
Modulation mode
Channel
Wireless ID
Group
Other
Display
Dimension/Weight
2.4G Wireless Frequency Range
Max. Transmitting Power of 2.4G Wireless
XProO
Upgrade through the Type-C USB port
Settings will be stored 2 seconds after last operation
and recover after a restart
0-100m
2.4G
MSK
32
01-99
16
Large LCD panel, backlighting ON or OFF
90x58x50mm/80g
2413.0MHz-2464.5MHz
5dbm
Restore Factory Settings
Synchronously press the two function button in the middle, and the restore factory
settings are finished until the “RESET” is displayed on the LCD panel.
Technical Data
Firmware Upgrade
This flash trigger supports firmware upgrade through the Type-CUSB port. Update
information will be released on our official website.
USB connection line is not included in this product. As the USB port is a Type-C
USB socket, please use Type-C USB connection line.
As the firmware upgrade needs the support of Godox G2 software, please
download and install the "Godox G2 firmware upgrade software" before
upgrading. Then, choose the related firmware file.
- 44 -
- 43 -