Why do my speakers hum when using a Gold Note PA-10 EVO Amplifier?
If your speakers hum when the Gold Note Amplifier is connected, first ensure your system is well-grounded and check the ground pin on the power cord plug. Also, verify that you are using shielded cables for all amplifier connections, as unshielded interconnect input or output cables can cause humming.
What to do if my Gold Note Amplifier does not work when switched on?
If your Gold Note Amplifier doesn't work when switched on, check the following: * Ensure the AC Stage plug is connected to a working wall power outlet. * Verify the interconnect cables are properly connected to the amplifier and are functioning correctly. * Inspect the fuse and replace it with one of the same value (5A T 5x20mm) if it's blown.
How to stop a Gold Note Amplifier from buzzing when turned on or off?
To prevent buzzing when turning your Gold Note Amplifier on or off, turn off the amplifier first and turn it on last within your audio system setup.
Covers product handling, service, environmental protection, and electrical safety guidelines.
Provides guidelines for proper disposal and recycling of the product as per EU directive.
Details power output, frequency response, THD, damping factor, input sensitivity, and amplifier capabilities.
Specifies power requirements, standby power consumption, and fuse rating.
Lists all audio input types, line outputs, and speaker terminal specifications.
Provides physical dimensions, weight, and recommended operating temperature/humidity.
Explains the function of the front panel controls and the LED indicator states.
Identifies and describes all connectors, switches, and ports on the rear panel.
Instructions for connecting the PA-10 EVO using RCA or XLR audio cables.
Guides for connecting two PA-10 EVOs for mono operation via XLR or RCA.
Details how to set up bi-wiring for speakers using two PA-10 EVOs in mono.
Explains how to use the balanced line output for connecting to other audio devices.
Information on registering the unit, warranty terms, and service procedures.
Advises on product handling, maintenance by qualified personnel, and avoiding damage.
Provides solutions for common problems like speaker hum or unit buzzing.
Guidelines for cleaning the unit's exterior with care to preserve its finish.
General| Power Output | 140W @ 8Ω / 250W @ 4Ω |
|---|---|
| Frequency Response | 20Hz-20kHz ±0.1dB |
| Signal-to-Noise Ratio | > 100dB |
| Inputs | 1x RCA, 1x XLR |
| Dimensions | 220mm W x 120mm H x 360mm D |
| Weight | 8 kg |
| Damping factor | > 200 |
| Input impedance | 10kΩ |
| Input sensitivity | 1.4V |
| Gain | 32dB |
| Outputs | Speaker terminals |
| Total Harmonic Distortion (THD) | <0.01% |
| THD | < 0.01% |
| Total Harmonic Distortion | < 0.01% |
To Next Page
