Gold Note PA-10 EVO - Front Panel Overview; Front Panel Controls and LED Status

2
FRONT PANEL OVERVIEW
The LED id blue when the PA-10 EVO is
switched on and ready to play. The red LED
indicates that the amplifier is on standby,
this is only possible when using the GN Link
trigger.
The LED is purple when both audio channels
are muted during power-up while the
amplifier reaches the optimal operating
conditions.
| FRONT PANEL
If the PA-10 EVO goes into protection mode
while playing music, the LED turns purple
and both audio channels are muted until the
amplifier can operate normally again.*
*Please note that the amplifier will resume
playing at the same volume level, no
attenuation is applied.
1
LED status light
1
Red = Standby
Blue = ON
Purple = Powering up / Protection mode
EN
DE
IT
FR