TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
Matching the cartridge with PH-10.
Buzzing noise coming from the
loudspeakers.
PH-10 is not working.
The MC cartridges need specific
impedance values.
The MM cartridges need a 47KΩ
load.
The phono stage is very sensitive to
the surrounding environment.
The power cord is not plugged in.
The ground connector is not
plugged in correctly.
The interconnect cables are not
connected to the tonearm.
The interconnect inputs are not
plugged in.
The IEC fuse is blown.
The listening volume is very high while
no music is playing.
The tonearm and the cartridge are not
installed properly.
The interconnect cables used on the
input/output are not shielded.
Refer to the manufacturer's specifications to set up
MC cartridges.
MM cartridges do not require any adjustment.
The PH-10 has a fixed capacitance of 330pF.
Try different placements of the phono stage and
ensure that the environment is not affected by
RFI/EMI.
Always use only shielded cables.
Connect the power cord properly and ensure the
power outlet is working.
Try to plug and unplug the ground connectors to find
the best solution for your specific audio system.
Ensure that the interconnect the cables are properly
plugged in.
Always connect the interconnect input to test how the
phono stage performs.
Replace it with one of the same value.
High performance phono stages will produce a buzzing
noise when the volume is high. It's normal when no
music is playing and with MC gain selection.
Check the installation and the tonearm.
Always use only shielded cables.
9
Für Ersatzteile besuchen Sie bitte den offiziellen Golf Note Shop unter:
http://www.akamaiaudio.it/
To Next Page
Loading...
Need help?
General
