Gold Note PSU-10 EVO - Quick Start Guide; Positioning PSU-10 E DS-10

INSTALLING THE PSU-10 EVO IS SIMPLE AND TAKES ONLY A FEW QUICK STEPS
1. Disconnect the DS-10 removing the AC power cord
2. Connect the PSU-10 EVO to the AC power outlet using the supplied power cord
3. Connect the PSU-10 EVO to the DS-10 using the supplied cable (see the image below)
4. Turn on the MASTER SWITCH on the rear panel of the PSU-10 EVO and then switch ON the DS-10 with the SKC
7
QUICK START
MASTER
PSU OUT
AC
R L
R L
AES/EBU
COAXUSB HOST USB DAC
GN LINK
AC IN 100 - 240 V
PSU IN
TOS 1 TOS 2
WI-FI
ANTENNA
LINE-IN
WPS
WI-FI
RESET
WI-FI
LED
ETHERNET
UNBALANCED
BALANCED
SERIAL NUMBER
DS-10 PSU-10 EVO
GND