32
Tape
15
18
12
Raise Backboard to 10 FT. regulation playing height. Measure from top of rim straight down to the playing
surface.
Using tape - mark the side of the steel actuator (#12) just under the plastic actuator sleeve (#18) at this 10 ft rim
height. See Figure 1.
Lower backboard all the way down. Do not force actuator once backboard is in it's lowest position.
See Figure 2.
Do not remove adhesive backing from height decal (#15) yet. Carefully place height decal on backside of steel
actuator and line up the 10 ft mark on the tape with the 10 ft mark on the height decal. Decal should fit correctly
onto the backside of the steel actuator. ( If not, simply trim to fit the top of the actuator decal).
SET AT 10 FEET HIGH LOWER ALL THE WAY DOWN
To Next Page
Loading...