Need help?Do you have a question about the GOMspace NanoPower P60 Dock and is the answer not in the manual?
Guidance on safely unpacking and handling the ESD sensitive P60 Dock device.
Details on global variables and default settings for the P60 Dock command line interface.
System-level parameters for the P60 Dock, typically configured from the factory.
Parameters for controlling the 13 output channels of the P60 Dock, including naming and enabling.
Manages output channels based on battery mode, voltage levels, and current limitations.
Settings for battery pack type, and control of the battery heater based on temperature.
Covers calibration settings for measurements and parameters for monitoring system status.
Manages module configurations, including default settings and ground watchdog functions.
Monitors satellite bus and CSP connectivity, triggering actions on failure.
Enables deployment of NanoCom ANT6 and AR6 modules with configurable delays.
Lists the specific CSP port numbers used by the P60 Dock for communication.
API functions to retrieve and modify P60 Dock configuration parameters remotely.
API functions to retrieve housekeeping data from the P60 Dock.
API function to reset the ground watchdog timer for configuration safety.
Details system-level configuration parameters for the P60 Dock, requiring reboot to take effect.
Covers runtime configuration parameters for output channels, battery, and watchdogs.
Defines gain and offset parameters for voltage and current measurements.
Lists telemetry data values updated by the housekeeping task, including status and measurements.
General| Input Voltage | 5V |
|---|---|
| Output Voltage | 5V, 3.3V, Adjustable (via I2C) |
| Operating Temperature Range | -40°C to +85°C |
| Input Voltage Range | 4.5V to 5.5V |
| Protection Features | Overcurrent, Overvoltage, Short Circuit |
To Next Page