To Next PageTo Next Page
Need help?Do you have a question about the Goodman ASPT30C14 and is the answer not in the manual?
Covers high voltage, disconnect power, property damage, injury, death warnings.
Emphasizes requirement for trained technicians for installation and repair.
Stresses the need for an uninterrupted electrical ground circuit.
Warns about CO poisoning risk in enclosed areas with combustion devices.
Warns against storing flammables and using uncertified devices.
Specifies required clearances and guidelines for horizontal installations.
Details the process and required kits for downflow/horizontal right installations.
Guidelines for routing refrigerant tubing and selecting the correct tubing size.
Instructions for preparing tubing ends and safety precautions during brazing.
Detailed steps for connecting refrigerant lines on flowrator models.
Steps for connecting refrigerant lines on TXV models, including CAUTION.
Covers drain pan connections, pitching, insulation, and traps for condensate lines.
Instructions for installing electric heat kits and using temperature rise tables.
Requirements for inspecting the building's electrical supply voltage for the unit.
Guidelines for selecting appropriate wire sizes to minimize voltage drop.
Covers fire hazards, high voltage, and proper grounding procedures.
Covers high voltage, disconnect power, property damage, injury, death warnings.
Emphasizes requirement for trained technicians for installation and repair.
Stresses the need for an uninterrupted electrical ground circuit.
Warns about CO poisoning risk in enclosed areas with combustion devices.
Warns against storing flammables and using uncertified devices.
Specifies required clearances and guidelines for horizontal installations.
Details the process and required kits for downflow/horizontal right installations.
Guidelines for routing refrigerant tubing and selecting the correct tubing size.
Instructions for preparing tubing ends and safety precautions during brazing.
Detailed steps for connecting refrigerant lines on flowrator models.
Steps for connecting refrigerant lines on TXV models, including CAUTION.
Covers drain pan connections, pitching, insulation, and traps for condensate lines.
Instructions for installing electric heat kits and using temperature rise tables.
Requirements for inspecting the building's electrical supply voltage for the unit.
Guidelines for selecting appropriate wire sizes to minimize voltage drop.
Covers fire hazards, high voltage, and proper grounding procedures.
General| Model | ASPT30C14 |
|---|---|
| Type | Air Handler |
| Refrigerant | R-410A |
| Tonnage | 2.5 |
| Voltage | 208/230 |
| Phase | 1 |
| Frequency | 60 Hz |
| Cooling Capacity (BTU/h) | 30000 |
| Width | 21.5 |
