PROBLEM POSSIBLE CAUSE SOLUTION
No sound
Connections incorrect or loose.
Volume knob at zero.
Check all connections and
correct as required. Turn up
the volume knob.
Poor radio reception
The wire antenna is not extended and
arranged correctly.
Extend the wire antenna to
ensure the best reception.
No CD
playback
The disc is dirty. The disc is upside
down. The CD player is on Pause.
Clean or replace the disc. Turn
it over, placing the label
upwards. Remove the Pause
mode.
The remote control
does not work.
An obstacle blocks the signal
between the remote control and the
unit's sensor. The remote control's
batteries are low.
Remove any obstacles.
Replace the batteries.
All functions are
inoperative.
The microprocessor is disturbed by
exterior electronic disturbances.
Unplug the Micro System the
unit for a few minutes, then
turn it back on.
To Next Page
Loading...
