GOODRICH Stormscope WX-950 - Default Chapter; Table of Contents

WX-950
Installation Manual
iii
Rev. C
TABLE OF CONTENTS
Paragraph Page
Chapter 1
GENERAL INFORMATION
1.1 INTRODUCTION............................................................................................................................1-1
1.2 FUNCTIONAL DESCRIPTION.....................................................................................................1-2
1.3 PHYSICAL DESCRIPTION ...........................................................................................................1-3
1.3.1 Display/Processor ............................................................................................................................1-3
1.3.2 Antenna ..........................................................................................................................................1-4
1.4 SPECIFICATIONS..........................................................................................................................1-5
1.5 INTERFACE....................................................................................................................................1-6
1.6 EQUIPMENT REQUIRED NOT SUPPLIED ...............................................................................1-6
1.7 INSTALLATION APPROVAL........................................................................................................1-6
1.8 WARRANTY INFORMATION .......................................................................................................1-6
1.8.1 Warranty Statement .......................................................................................................................1-6
1.8.2 Related Policies and Procedures.....................................................................................................1-7
Chapter 2
INSTALLATION
2.1 INTRODUCTION............................................................................................................................2-1
2.2 UNPACKING AND INSPECTING................................................................................................2-1
2.3 PRE-INSTALLATION TEST PROCEDURE.................................................................................2-1
2.3.1 Equipment Required.......................................................................................................................2-1
2.3.2 Test Procedure.................................................................................................................................2-2
2.4 ANTENNA LOCATION..................................................................................................................2-3
2.4.1 Interference Sources........................................................................................................................2-4
2.4.2 Skin Current....................................................................................................................................2-4
2.4.3 Skinmapping....................................................................................................................................2-4
2.4.4 Ground Plane...................................................................................................................................2-4
2.4.5 Alignment .....................................................................................................................................2-5
2.4.6 Slipstream .....................................................................................................................................2-5
2.4.7 Site Selection ...................................................................................................................................2-5
2.5 ANTENNA AND DOUBLER INSTALLATION............................................................................2-6
2.6 DISPLAY/PROCESSOR LOCATION.............................................................................................2-8
2.7 CABLE REQUIREMENTS AND FABRICATION........................................................................2-8
2.7.1 Antenna Cable ..............................................................................................................................2-11
2.7.2 Power Cable...................................................................................................................................2-12
2.7.3 Heading Input Cable.....................................................................................................................2-12
2.7.4 Inhibit Line ...................................................................................................................................2-15
2.7.5 Remote Clear Line.........................................................................................................................2-15
2.8 MATING CONNECTOR ASSEMBLY .........................................................................................2-16
2.9 DISPLAY/PROCESSOR INSTALLATION..................................................................................2-20
2.10 PERFORMANCE TEST................................................................................................................2-21