Why does my Goodway GVC-18000 vacuum not suck up dirt effectively?
To resolve ineffective dirt suction with your Goodway Cleaning Equipment vacuum, start by cleaning or replacing the filter. Also, inspect the housing for any blockages that might be hindering performance.
What to do if my Goodway GVC-18000 Cleaning Equipment has no steam output but is pressurized?
If your Goodway Cleaning Equipment isn't producing steam despite being pressurized, ensure that the manual output valve is fully open.
What to do if the vacuum does not turn on when enabled on the hose-grip of my Goodway GVC-18000?
If the vacuum on your Goodway Cleaning Equipment doesn't turn on when enabled on the hose-grip, first, verify that the vacuum is correctly plugged in. Secondly, ensure that the vacuum unit itself is switched on.
What to do if the hose plug is hard to insert in the machine socket of my Goodway GVC-18000 Cleaning Equipment?
If you are having difficulty inserting the hose plug into the machine socket of your Goodway Cleaning Equipment, lubricate the steam socket connection with some silicone.
What to do if the pressure rises rapidly and the pump continues to fill the boiler of my Goodway GVC-18000 Cleaning Equipment?
If the pressure in your Goodway Cleaning Equipment rises rapidly and the pump continues to fill the boiler, the machine requires servicing.
Why is steam leaking from accessories of my Goodway GVC-18000 Cleaning Equipment, or why are they hard to disconnect?
If steam is leaking from the accessories of your Goodway Cleaning Equipment, or if they are hard to disconnect, replace the gaskets and clean them. Then, apply a light film of silicone grease on the gasket.
What to do if the pressure drops rapidly during operation of my Goodway GVC-18000?
If the pressure drops rapidly during operation of your Goodway Cleaning Equipment, remove scale from boiler as described in the maintenance section.
Why is the machine heating time too long for my Goodway GVC-18000?
If your Goodway Cleaning Equipment is taking too long to heat up, remove scale from the boiler as described in the maintenance section.
Why are all the LEDs blinking on my Goodway Cleaning Equipment?
When all LEDs and the display of the front panel of your Goodway Cleaning Equipment start blinking and the display shows letters or numbers, the voltage is insufficient to run the machine.
Essential safety precautions for operating the dry-steam cleaner to prevent injury and damage.
Procedure and importance of proper grounding for electrical safety against shock.
Identifies and lists components of the steam cleaner's front control panel.
Details the controls and indicators on the boiler control panel.
Explains how to use the P1 and P2 buttons to read the machine's total running hours.
Describes the controls and indicators for wet steam and detergent functions.
Details the water tank inlet and associated components.
Details the steam handle and its associated buttons and levers.
Describes the optional hose-grip for steam and vacuum functions, including controls.
Step-by-step guide for operating the machine using steam only.
Explains how to inject water or detergent into the steam for enhanced cleaning.
Procedures to follow after using the continuous water refill feature.
Step-by-step guide for cleaning the machine's boiler to prevent scale buildup.
Information on chemical scale removal and contacting support.
Guidance on inspecting and replacing the water filter.
Visual steps to get the machine started for the first time.
Visual steps for safely shutting down the steam cleaner.
Lists common problems and solutions related to the optional vacuum accessory.
General| Model | GVC-18000 |
|---|---|
| Category | Cleaning Equipment |
| Power | 1800W |
| Voltage | 220-240V |
| Frequency | 50/60Hz |
| Hose Length | 2.5m |
| Power Source | Electric |
| Airflow | 3.0 m³/min |
To Next Page
