11
Troubleshooting
ATTENTION!
Instruction manual
t
– Read all warnings and operating instructions thoroughly before use so
that you understand them.
– DO NOT OVERLOAD THE FLOOR JACK beyond its rating capacity.
– This floor jack is only a lifting device.
– This floor jack is only designed for use on an even, hard surface.
– The load must be immediately supported by other suitable means.
– Do not move or reposition the vehicle whilst it is lifted by the floor jack.
– Only lift the vehicle at areas intended for this purpose by the
manufacturer.
– Only add-on parts and/or adapters supplied by the manufacturer may be
used.
– No modifications must be made to the floor jack.
– Failure to follow these warnings can lead to damage to the floor jack
and/or to personal injury or material damage.
– Check the appliance before each use.
If this device is to be disposed of, please contact your local dealer or a
local recycler. Under no circumstances should the device be sent to a
municipal collection point. Do not dispose of the device with household
waste. By doing so, you are making an important contribution to
protecting the environment. Hydraulic oils must be disposed of at
hazardous waste collection points.
PROBLEM Possible causes Action
The jack cannot Oil level Check the
be extended to too low oil level
its full height
The floor jack will Release valve will Consult the
not hold the load close. Hydraulic oil is customer service
contaminated. department
Pump valves will not
shut tight.
Cylinder thrust plate
sticks
The lifting arm cannot Consult the
be lowered customer service
department
· Cylinder thrust
plate sticks
· Parts worn
· Internal damage
· Broken or
unhooked return
springs
· Connection point
on the lifting arm
bent or sticking
75518 Bed. A5_130411.indd 11 11.04.13 10:13
DISPOSAL
To Next Page
Loading...