Why does a fuse blow as soon as the Gorenje Hob is switched on?
If a fuse blows as soon as the Gorenje Hob is switched on, it means that the hob has been wrongly connected. Check the electrical connections.
What to do if there is no power supply to my Gorenje GHT63B?
If there is no power supply to your Gorenje Hob, check the fuses or the electric switch (if there is no plug).
What to do if my Gorenje GHT63B shows fault code E2?
If the Gorenje Hob displays a fault code E2, it means that the electronics have overheated, possibly because a pan was too large or the hob is insufficiently ventilated. Let the hob cool down until the code disappears and make sure it is sufficiently ventilated.
What to do if my Gorenje Hob shows a fault code when I touch two buttons?
If the Gorenje Hob displays a fault code because you touched 2 buttons at the same time, operate 1 button at a time.
What to do if a cooking zone suddenly stops and I hear a signal on my Gorenje GHT63B?
If a cooking zone on your Gorenje Hob suddenly stops and you hear a signal, it means that the preset time has ended. Switch off the audible sound by pressing the + or - button of the kitchen/ egg timer.
Why does my new Gorenje GHT63B have a slight smell when I use it?
A slight smell is noticeable the first few times the Gorenje hob is used because the new appliance is heating up. This is normal and will disappear once it has been used a few times. Ventilate the kitchen.
Why can I hear a ticking sound in my Gorenje GHT63B Hob?
The ticking sound you hear in your Gorenje Hob is caused by the capacity limiter on the front and back zones. Ticking can also occur at lower settings. This is normal operation.
General| Type | Gas Hob |
|---|---|
| Number of burners | 3 |
| Color | Black |
| Control | Mechanical |
| Surface Material | Tempered glass |
| Width | 60 cm |
| Gas Type | Natural gas/LPG |
| Material | Glass |
| Ignition Type | Automatic |
| Safety Features | Flame failure device |
To Next Page