Gorenje GS671C60X - User Manual

Questions and Answers

D
Debra DeanAug 21, 2025
How to improve cleaning performance of my Gorenje GS671C60X?
- J
  Joan ShermanAug 21, 2025
  If your Gorenje Dishwasher isn't cleaning dishes properly, start by checking if the spray arms rotate freely and that the dishes aren't blocking them. Remove the spray arms and clean them, paying attention to any blocked holes or bearings. Select a more intensive program for greasy dishes. Ensure correct detergent dosage according to water hardness; using too much or too little can affect results.
T
tylerzamoraAug 25, 2025
How to remove grease deposits in my Gorenje GS671C60X?
- E
  Erin Cooper DVMAug 25, 2025
  To address grease deposits in your Gorenje Dishwasher, select a high-temperature program like Intensive wash for very dirty dishes, or run the self-cleaning program.
C
Claudia EllisonAug 26, 2025
How to remove spots left after washing in my Gorenje Dishwasher?
- M
  Matthew MillerAug 26, 2025
  If your Gorenje Dishwasher leaves spots after washing, especially from lipstick or tea, use a detergent with a bleaching agent.
W
William TorresAug 27, 2025
Why does water remain in my Gorenje Dishwasher?
- J
  Jennifer AguilarAug 28, 2025
  To resolve the issue of water remaining in your Gorenje Dishwasher, start by cleaning the coarse and fine filters. Ensure the filter handle is locked in the stop position. Additionally, inspect the drainage pump for debris and clean it if necessary. Check that the colored stop on the right in the bottom drain is in place. Also, make sure the drainage hose is free from kinks and sharp bends. Finally, disconnect the drainage hose from the sink unit's water trap to check for blockages, ensuring the connection has an inner diameter of at least 14 mm.
M
Malik NguyenAug 29, 2025
Why are there spots or films on the dishes from my Gorenje Dishwasher?
- M
  michaeltaylorAug 29, 2025
  If your Gorenje dishwasher leaves spots or films on the dishes, it could be due to several reasons: the water softener might be leaking salt (check the compartment lid), the water softener or rinse aid dosage might be incorrectly set, or the salt compartment might be empty (top it up). If you're using 3-in-1 detergent with the TAB setting activated, try inactivating the setting and adding salt and rinse aid separately. High temperatures or too much detergent can also cause etching on crystal; wash crystal at a lower temperature with less detergent.
J
Jonathan NavarroAug 31, 2025
How to fix Gorenje Dishwasher if the dishes are not dry enough?
- K
  Kimberly WilsonSep 1, 2025
  If your Gorenje Dishwasher leaves dishes not dry enough, activate the Auto open option. Make sure you fully load the dishwasher. Check and top up the rinse aid or increase its dosage. If you are using a 3-in-1 detergent and the TAB setting is activated, try inactivating the TAB setting and top up salt and rinse aid separately.
K
Katrina BryantSep 2, 2025
Why Gorenje GS671C60X Dishwasher buttons do not react when pressed?
- G
  george31Sep 3, 2025
  To address the issue of buttons not reacting on your Gorenje Dishwasher, wait a moment before pressing them after opening the door. Ensure the buttons are clean using a dry or slightly damp cloth. The buttons are designed to work only when the door is open. Also, verify that the baskets are correctly positioned horizontally and that dishes aren't obstructing the baskets from sliding into place.
J
James SteeleSep 4, 2025
How to get rid of bad odour in Gorenje Dishwasher?
- J
  Jennifer WallaceSep 4, 2025
  If your Gorenje Dishwasher has a bad odor, clean around the seals and in the corners with a washing-up brush and a low-foaming cleaner. If you've been using low-temperature programs for a long time, run a higher temperature program about once a month or select the self-cleaning program.
G
Glenda CainSep 6, 2025
What to do if my Gorenje GS671C60X is overfilling?
- M
  Marvin BautistaSep 7, 2025
  If your Gorenje Dishwasher is overfilling, clear the drainage pump.
J
Joshua AndersonSep 8, 2025
What to do if my Gorenje GS671C60X Dishwasher shows a water inlet fault?
- M
  Mr. Paul Barnes DDSSep 8, 2025
  To resolve a water inlet fault in your Gorenje Dishwasher, check that the water tap is on and that the outer filter on the inlet hose is not blocked.