473238
What you need to consider
• The connection must comply with national and local
regulations.
• The appliance must always be earthed.
• This appliance may only be connected by a competent
electrical installer.
• For the connection, use an approved cable (for example
type HO7RR) in accordance with the regulations. The
cable casing should be of rubber.
• The connection cable must hang freely and is not to be
fed through a drawer.
• If the connecting cable is damaged, it may only be
replaced by the manufacturer, the manufacturer’s
service organisation or equivalently qualifi ed persons, in
order to avoid dangerous situations.
• If you want to make a fi xed connection, make sure that a
multi-polar switch with a contact separation of at least 3
mm is fi tted in the supply line.
• The worktop the hob is built into must be fl at.
• The walls and the worktop surrounding the appliance
must be heat resistant up to at least 85 °C. Even though
the appliance itself does not get hot, the heat of the hot
pan could discolour or deform the wall.
• Damage caused by incorrect connection, installation or
use, will not be covered by the guarantee.
Clearance
Su cient all-round clearance is essential to the safe use of
the hob. Check that there is enough clearance.
What you need to
consider
cooker hood
cabinet
side wall
hob
19
INSTALLATION
To Next Page
Loading...
