QTY. (2)
5/16" Split Lock Washer
QTY. (2)
5/16" Flat Washer
5/16" x 1" Hex Bolt
QTY. (2)
#8 x 2-1/2" Wood Screw
QTY. (6)
3: RE-INSTALL 2470F USING 2-1/2" SCREWS AS SHOWN.
Panel Support
Bracket 11-9010
90
DRILL
3/8" HOLE
DR
I
L
L
90 Bracket 11-9010
3
4
"
DRILL A 3/8" HOLE THROUGH THE PANEL SUPPORT.TEMPLATE
STEP 18: ROCK WALL TO FORT
1: PLACE THE ROCK WALL CENTERED ON THE RIGHT SIDE ON THE FORT. THE BOTTOM EDGE OF THE GREEN
BRACKETS SHOULD BE
3/4" ABOVE THE BOTTOM OF THE PANEL SUPPORT. USING THE BRACKETS AS A
4: WHEN THE 90
BRACKETS ARE SECURE, AND THE ROCK WALL IS IN ITS FINAL POSITION; FULLY TIGHTEN
ALL BOLTS.
2: REMOVE
2470F
AND INSERT T-NUTS INTO THE BACK SIDE.
5/16" T-Nut
2470F
PANEL SUPPORT
To Next Page