STEP 4: ASSEMBLING THE ROCK WALL
1: START WITH THE 4 X 4 X 80-1/4" ROCK WALL SIDES. THE SIDES SHOULD BE POSITIONED IN A MANNER THAT
ALLOWS THE ANGLED ENDS TO FACE THE SAME WAY. IT SHOULD ALSO BE NOTED THAT THERE ARE TWO 3/8"
HOLES JUST BELOW THE ANGLED ENDS.
2: INSTALL T-NUTS INTO THE HOLES JUST BELOW THE ANGLED ENDS. THE BOTTOM HOLES WILL GET A T-NUT ON THE
OUTSIDE, AND THE TOP HOLES WILL GET A T-NUT ON THE INSIDE.
3: FIND THE 4 X 4 X 80" ROCK WALL BOTTOM SUPPORT. LINE UP THE 3/8" PILOT HOLES ON THE ROCK WALL
BOTTOM SUPPORT TO THE COUNTER-SUNK HOLES ON THE ROCK WALL SIDES.
4: FIND TWO T-NUTS, AND SET WITH A HAMMER ON THE EXPOSED 3/8" HOLES OF THE ROCK WALL BOTTOM
SUPPORT.
5: FASTEN THE ROCK WALL BOTTOM SUPPORT TO THE ROCK WALL SIDES WITH 5/16 X 6" HEX BOLTS AND 5/16"
WASHERS THROUGH THE COUNTER-SUNK HOLES OF THE ROCK WALL SIDES AND INTO THE T-NUTS INSTALLED IN THE
ROCK WALL BOTTOM SUPPORT.
ROCK WALL SIDE
BOTTOM SUPPORT
T-NUT
HEX BOLT
5/16 X 6"
5/16" WASHER
4 X 4 X 80-1/4"
4 X 4 X 80"
ROCK WALL
T-NUT
To Next Page
Loading...
