STEP 21: ROOF SUPPORT
1: FIND FOUR 2 X 6 X 80-1/4" ROOF SUPPORT BOARDS. THERE WILL BE TWO FOR THE LEFT, AND TWO FOR THE
RIGHT.
2: LAY THE ANGLED ENDS (WITH THE ENGRAVED DESIGNS) ON TOP OF THE SWING BEAM SIDE RAIL, AND THE SIDE
RAIL. ALLOW SOME OF THE BOARD TO HANG PAST THE SIDE RAILS SO THAT THERE WILL BE NO INTERFERENCE WITH
THE TARP BOARDS AND THE ROOF BOARDS THAT WILL BE INSTALLED LATER.
3: ATTACH THE ROOF SUPPORTS TO THE CORNER POSTS WITH 3/8 X 3-1/2" LAG SCREWS AND 3/8" WASHERS.
2 X 6 X 80-1/4"
ROOF SUPPORT
BOARD
3/8" WASHER
3/8 X 3-1/2"
LAG SCREW
To Next Page
Loading...
