2-way Pager Antenna Installation
STEP 1
Mounting the antenna module.
Find a secure place on the motorcycle where you can mount the 2-way antenna
module using hook and loop strips. The most common area for installation are:
The antenna module must be installed in a locationthat should not become wet.
Step 2
Route the 2-way antenna wire to the alarm unit while
keeping the wire hidden and secure.
Step 3
Connect the black 3-pin plug from the antenna wire to
the matching black 3-pin plug on the alarm unit.
Section 2
Programming the 2-way Pager System
12
The Gorilla Cycle Alarm with 2-way Pager System (part # 8017) is serious protection for
those that want the ability to keep track of their motorcycle’s security at all times.With the
2-way pager, every function of the alarm can be monitored on the pager’s LED screen
from up to 1/2 mile away
*
. Each alarm unit can accommodate up to 3 pagers and can be
purchased separately.
*
If the system is interrupted by strong radio frequency, high voltage electrical power or obstacles
like tall buildings, the transmission
range may be shorten.
1
2
3
4
1
2
3
4
To Alarm module
WITHIN TAIL SECTION
BEHIND SIDE COVERS
UNDER SEAT
WITHIN FAIRING
2-way antenna
module
To Next Page
Loading...