*The GoScribe Mini remembers the data from the last tag that was engraved. This saves time
engraving many tags of the same information even if each tag is a different shape. Or if for
example a customer needs 10 pet tags and they all have the same address and phone number
but different pet names you need only edit the pet name on each tag. If you are engraving a
completely new tag then just use the quick Control + N combination to remove all data from the
tag and start fresh.
*The GoScribe Mini was engineered to make a nice scribe on the first pass. Yet sometimes you
may want a deeper scribe. Since the data is stored from the previous tag you may simply
choose the tag shape again and press Go to scribe it one more time for a deeper engraving.
Maintenance
The GoScribe has been engineered to require very little maintenance. All that is necessary is to
clean the inside of the machine with a soft cloth from time to time when dust and engraving
particles build up. Unplug the machine while doing cleaning. Wipe down all the parts you can
reach with a soft cloth. For the pink vacuum material rub it clean with soap and water and then
dry when finished.
To Previous Page
Loading...