Lift the tiller upright (as shown in the gure).
Once the scooter is locked in the upright
position, verify by gently trying to fold.
X Assemble YourScooter
Toolrequirements:ammAllenwrench(Inthepackage)
Take out the scooter, console, and assembly
tools(wrench and screws) from the box. Check
the parts list to confirm that the parts are not
damaged or lost during transportation.
Pull the handbrake towards you and insert the
round metal piece into the opening. String the
small silver cord through the solid piece of the
handbrake. Make sure the metal piece on the
brake cord is pushed fully into the handbrake.
Lift the tiller upright (as shown in the figure).
Once the scooter is locked in the upright
position, verify by gently trying to fold.
Conect the power cord between the tiller and
the console, then insert the console above the
tiller until the screw holes on the tiller and
console are aligned, install the screwson the
screw holes of the tiller and tighten with a
wrench.
10
To Next Page
Loading...
