Need help?Do you have a question about the Goulds Pumps HSC and is the answer not in the manual?
General| Type | Centrifugal |
|---|---|
| Model | HSC |
| Horsepower | Varies with model |
| Discharge Size | Varies with model |
| Application | Industrial, Commercial |
| Maximum Flow Rate | 2000 GPM |
| Maximum Head | 300 ft |
| Impeller Diameter | Varies with model |
| Speed | Varies with model |
| Suction Size | Varies with model |
| Material | Cast Iron, Stainless Steel |
Covers thermal protection, overload requirements, and switch selection.
Specifies limits for liquid temperature, working pressure, and start frequency.
Guidance on regular inspection and maintenance for extended service life.
Advice on pump placement, adequate space, and independent piping support.
Guidance on selecting fittings, avoiding stress, and unit orientation.
Warning to always disconnect electrical power when handling pump or controls.
Desired conditions for suction piping, consulting NPSHR for lifts above 15'.
Ensuring suction pipe is at least pump connection size; using eccentric reducers.
Avoiding air pockets, sloping piping upward, ensuring airtight joints.
Requirement for a check valve between gate valve and pump for regulation/inspection.
Positioning an increaser between the check valve and pump if required.
Using Teflon tape to seal threaded connections for proper sealing.
Verifying correct right-hand (clockwise) rotation by quick power cycling.
Ensuring pump is primed, discharge valve partially open before starting.
Performing a complete check after the unit stabilizes under operating conditions.
Motor ball bearings are permanently lubricated and require no greasing.
Caution against running the pump dry to prevent seizing and seal damage.
Outline of procedures for disassembling the pump liquid-end.
Ensuring seal components are in good condition for proper function.
Checking impellers and wear rings for wear, degradation, or blockages.
Guide to diagnosing and resolving common problems like motor not running or low delivery.
List of pump parts with item numbers, names, quantities, and motor codes.
Details on motor horsepower, model numbers, and corresponding order numbers.
One-year warranty from installation or twelve months from shipment date.
Buyer's responsibility for notice, costs, and Seller's option for repair/replacement.
List of conditions and actions that void the warranty or are not covered.
To Next Page
