What to do if my Goulds Water Pump delivers water but will not shut off?
If your Goulds Water Pump delivers water but doesn't shut off, it could be due to a plugged or incorrectly adjusted pressure switch. In this case, you should clean and adjust the pressure switch. Another potential cause is a defective suction check or foot valve, which would require replacement.
Why is my Goulds HSJ20 not running?
If your Goulds Water Pump isn't running, there are several potential reasons. First, the motor thermal protector may have tripped; try resetting it. Second, check for an open circuit breaker or a blown fuse and replace them if necessary. Finally, the motor itself might be defective, requiring replacement.
What to do if my Goulds HSJ20 Water Pump cycles excessively?
If your Goulds Water Pump cycles excessively, it could be due to a water-logged pressure tank. Try draining and recharging the pressure tank. Another cause might be the pump being farther than 5 feet from the tank; move the pump closer. High friction loss valves between the pump and tank may also be the reason; replace them with fully open gate valves to reduce friction loss.
How to fix little or no liquid delivered by Goulds HSJ20 Water Pump?
If your Goulds Water Pump delivers little or no liquid, it could be due to several reasons. First, the pump might not be primed, the suction pipe submergence may be inadequate, or there could be an air leak in the suction pipe. Prime the pump and ensure the suction pipe is correctly submerged and free of leaks. Second, the discharge or suction may be plugged, or a valve may be closed; clear any blockages and ensure valves are open. Finally, the suction lift or suction losses may be excessive; reduce suction lift and minimize losses.
General guidelines for plumbing installation, emphasizing code compliance and pipe material selection.
Instructions for installing shallow well systems, including suction and discharge piping considerations.
Installation details for deep well systems using a twin pipe jet assembly.
Installation procedures for deep well systems using a packer jet assembly.
Guidelines for discharge piping for deep well systems, including pressure control valve requirements.
Instructions for installing Goulds Water Technology HydroPro water system tanks, including pre-charge checks.
Procedures for priming both shallow well and deep well jet pump systems.
Instructions for connecting and powering the pump motor, including safety precautions.
Instructions for setting up and operating booster pump systems.
Procedures for preparing pumps for seasonal service, including draining for freeze protection.
Information on motor voltage changes, terminal board design, and wiring diagrams.
General| Model | HSJ20 |
|---|---|
| Type | Jet Pump |
| Flow Rate | 20 GPM |
| Motor Power | 2 HP |
| Material | Cast Iron |
| Voltage | 115/230 V |
| Maximum Capacity | 20 GPM |
| Discharge Size | 1 inch |
| Switch Type | Pressure Switch |
| Seal Type | Mechanical Seal |
| Phase | Single Phase |
| Suction Size | 1 1/4 inch |
| Motor Enclosure | TEFC (Totally Enclosed Fan Cooled) |
To Next Page
